| 1. Arm material and construction |
Confirm the material grade, plate thickness, reinforcement, and design suitability for the intended load and operating environment. |
Review drawings and material documentation. Check that the arm is designed for the machine and duty cycle rather than choosing by appearance or weight alone. |
Inspect for cracks, deformation, corrosion, and damage around highly stressed areas during routine checks. |
| 2. Rated capacity and reach |
Check the approved load rating at the required reach, arm position, and attachment configuration. |
Use the manufacturer’s load chart and operating instructions. Capacity can change with geometry, machine setup, and the load’s position. |
Keep load charts available to operators and investigate any bending, unusual movement, or repeated overload events. |
| 3. Weld quality and stress points |
Examine welds, joint transitions, mounting areas, and other locations where loads are concentrated. |
Request inspection records where appropriate. Look for visible cracking, incomplete welds, sharp damage, or signs of unauthorized repair. |
Include weld areas in scheduled visual inspections; have suspected structural defects assessed by a qualified person. |
| 4. Wear protection and contact surfaces |
Identify surfaces exposed to abrasion, impact, sliding contact, or repeated contact with loads and attachments. |
Ask whether wear plates, replaceable liners, or other protective features are fitted where the application requires them. |
Check protective parts for thinning, looseness, or damage and replace them before wear reaches the structural arm. |
| 5. Pins, bushings, and pivot joints |
Assess pivot design, pin retention, bushing condition, and access to lubrication points. |
Check for excessive play, binding, misalignment, damaged retainers, or grease fittings that are difficult to reach. |
Follow the specified lubrication interval and inspect joints for wear; replace worn pins or bushings as recommended. |
| 6. Corrosion and surface protection |
Consider exposure to moisture, chemicals, outdoor storage, road salt, and abrasive material. |
Review the coating or surface-protection system and confirm it suits the working environment. Inspect edges and joints where coating damage may occur. |
Clean and touch up damaged protection as appropriate, and investigate corrosion that could reduce section thickness. |
| 7. Service access and documentation |
Check access to inspection points, lubrication locations, replacement components, and service instructions. |
Confirm that the operating limits, inspection guidance, parts information, and approved repair procedures are available for the specific arm. |
Plan inspections and servicing around the equipment’s actual use and service guidance; keep records of findings and repairs. |